American Wire Guards
Phone: 800-328-8996
Guard Finder
Height (in)
Width (in)
Depth (in)
 Extra Tolerance
Want to increase your product's value? Offer protective guards with your equipment to prevent damage, vandalism and theft. If you can't find an existing guard that works for you, use the Guard Builder form to tell us about your product, and we'll design a custom guard to fit it. You work hard to design your products, so let our guards protect them.

Guard Builder
Guards are usually mounted to a wall. If you have special instructions regarding your guard, the drawing illustrates what we consider height, width, depth, front and top.

Measuring your existing guard
1 Guard


Guard

Measure the inside dimension of the wires to
ensure full clearance of the object being covered.

Note

You may be required to rotate your guard to fit your object. Height and width are interchangeable on nearly all of our guards. Guards with a conduit spacer can still be rotated but may not fit over your conduit.

Rotate
Measuring your object
1 Exit Sample

Measure your Height and width and depth of your object.
These are the dimenisons you will enter in to the "Height,
Width, Depth" section of the Guard Finder.

2 Extra Tolerance

Remember that you'll need to allow for some clearance
around your object. This padding can vary from an one inch
up to 6 inches depending on the size of your guard.
Enter your desired padding in the Guard Finder.

Note

You may be required to rotate your guard to fit your object. Height and width are interchangeable on nearly all of our guards. Guards with a conduit spacer can still be rotated but may not fit over your conduit.

Rotate
American Wire Guards

Customer Service & Technical Support

Toll Free Phone:
1-800-328-8996

Toll Free Fax:
1-800-789-1882

American Time
ATTN: Wire Guard Division

140 3rd St. So.
PO Box 707
Dassel, MN 55325







American Time